Ubuntu: Increase Swap in Ubuntu 18.04 Under Lvm and Encrypted File System



Question:

I did a clean install of Ubuntu 18.04 Desktop.

I used the graphical installer and chose "Encrypt the new Ubuntu installation for security".

It used by default LVM and created a partition for the swap instead of the file. Here is sudo swapon -s result:

eviatan89@leviatan89-K55VD:~$ sudo swapon -s  Filename                Type        Size    Used    Priority  /dev/dm-2                               partition   1003516 999448  -2  

I need to increase the size as I am having lots of problems running low on RAM.

As curiosity, problems come when using Cassandra and Firefox with several open tabs (including YouTube). My system got 6GB of RAM.

Thanks a lot for your help!


Solution:1

The easiest solution would be to add a swap file. If you are already encrypting your root file system, I would not bother with an encrypted swap file, which is only a little more difficult, but it is slower. The advantage of a swap file is that you can remove it later to regain the disk space. And the disk is already encrypted!

The steps are straightforward. First, make the file. For example, this would make 1GB of new swap:

sudo dd if=/dev/zero of=/swapfile bs=1024 count=1024k  

The of=/swapfile tells dd to put the new swap file in /swapfile. You can call it anything you want. You can add multiple swap files, too. For recent Linux kernels, the speed is the same as a swap partition.

Then, you need to format the swap file as swap space, like so:

sudo mkswap /swapfile  

This command will give you some output like:

Setting up swapspace version 1, size = 1048576 KiB    no label, UUID=83352590-ef57-49f5-84c4-7fb847e4e4e0  

And that's your new swap file. Finally, you need to activate the swap on your machine using the following command:

sudo swapon /swapfile  

Now, sudo swapon -s should show you both the swap partition and the swap file.

I then recommend adding some security by changing permissions as follows:

sudo chown root:root /swapfile  sudo chmod 0600 /swapfile  

If all seems good so far, you can add the swap file permanently by adding the the following line to /etc/fstab using your favorite editor:

/swapfile       none    swap    sw      0       0  

You can add multiple swap files, of course. And you can remove the swap file by using sudo swapoff /swapfile.

Hope this helps.


Note:If u also have question or solution just comment us below or mail us on toontricks1994@gmail.com
Previous
Next Post »